40
C. Take the 3-point vehicle seat belt and put it through the vehicle seat belt routing slot
for Group II/III (see the element number 1). Next, take the lap belt and put it through
the red belt guides located on both sides of the safety seat (see element number 2)
D. Grab the entire safety seat fi rmly and make sure that it is properly attached, also
make sure that the belts are not twisted.
ATTENTION: Make sure that the lap belt is located at the same height as the hips of the
child and not at the height of the abdomen of the child.
A. Adjust the headrest height and fi nd mounting plates on the sides.
B. Turn the mounting plate by 90°, and pull it out with the strap
C. Remove the belt on both sides
REMEMBER: put all parts in a safe place
A. Make sure that the Top Tether tension indicator is facing outwards from the child
safety seat.
B. When attaching the Top Tether hook on the belt, make sure it points downwards.
C. When the hook is properly mounted and the tension indicator on the right side,
attach the mounting plates to the safety seat.
WARNING: make sure the belt is not twisted
REMOVING THE TOP TETHER SYSTEM
INSTALLING THE TOP TETHER SYSTEM
15
16
To Next Page
Loading...