© 2020 Carrier. All rights reserved. 1 / 20 P/N 10-5151-501-106-02 • ISS 15JUN20
KAL760 Addressable Input Module
Installation Sheet
EN ES IT PT FR NL CS NO PL HU
EN: Installation instructions
Description
The KAL760 provides a single remote input to an addressable
fire detection system.
The input signal is constantly monitored and its status
communicated to the fire panel. The module has five possible
states: standby, open circuit, short circuit, alarm 1, and
alarm 2.
Note: The input state is latched (this is not configurable) and
returns to standby after a system reset.
The input does not have polarity and may be activated by
closing a potential-free contact.
The module may be used with any device and the choice of
contact used (C, NC or NO) will set the desired event.
To Next Page
Need help?
General