9
Introduction Daily use
KIMAX2
Menu
Configuration
Calibration
Protecting
calibration
Electrical
installation
Sensor
installation
Additional
information
When the instrument is showing the total
weight
5
, it is possible to enter the Tare mode
by pressing . The LED next to turns on
and the value previously shown on the
display will be reset to 0,00 tons. When the
load changes (positive or negative) the
change will be shown in the display (as a
positive value). If a printer is connected to
the instrument it is possible to get a print
out by pressing . When printing from Tare
mode the Tare value will be printed as well.
Press once again to leave the Tare mode.
5
Total weight in this case means, that the instrument is showing the total weight for the truck + trailer if a trailer is
connected. Otherwise it is when showing the total weight of the truck.
To Next Page
Loading...