Assembly Instructions
Priority
Printed in U.S.A. © 2009 Kimball International, Inc. T 800.482.1818 F 812.482.8300
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 2008506 Revision B-09
P
age 2 of 2
Installation (continued)
3. Lay assembled organizer halves on their front. Attach gang
plates with fasteners provided as shown. (Figure C).
4. Make sure assembled unit is in its final desired position.
(Figure E). Carefully tilt unit forward and remove the
protective backing from each piece of double-sided adhesive
tape located on the bottom of unit. (Figure D).
5. Set unit upright and press down to ensure good bond with
adhesive. (Figure E).
Caution: Double-sided tape has a powerful adhesive which
permanently bonds to any surface.
Figure C
Figure D
Figure E
Gang Plate
Fastener
1" min.
Double-sided
Tape
6" min.
To Previous Page
Loading...