36
©2021 Kimberley Kampers Manufacturing Pty Ltd
Air Suspension Ride Height Setting Guide
The following is a guide for setting the ride height on Kimberley air suspensions. The measurements shown
are from the centre of the axle (or wheel) to the underside of the mudguard. The air suspension tted to your
Kimberley has a variable spring rate. The higher the airbag rubber sheath is above the base, the softer the ride
from the lowest possible spring rate.
Dropping the airbag sheath down towards the bottom of the bag increases the spring rate. This is suitable
from travel on main highways.
IMPORTANT:
DO NOT HAVE LOW LEVEL AIRBAGS IN OFF ROAD CONDITIONS UNDER ANY CIRCUMSTANCES.
• High - provides additional guard clearance and upward articulation for off road applications.
• Medium - the standard factory setting, which allows approximately the same articulation in both up and
down directions
• Low - suitable for at bitumen only
RIDE HEIGHT SETTING
Ride Height
Measurement
Conditions Recommendations
Karavan
Full Ext 600mm (23.6in) Inspections Do not travel like this
High 575mm (22.6in) High clearance Water crossings steep departures/entry’s
Mid 560mm (22in) Off road Best for corrigations and off road
Low 545mm (21.5in) Highway Highway only low absorbtion
Bottom 485mm (19.1in) Storage Do not travel like this
To Next Page
Loading...