INSTALLATION AND OPERATION
INSTALLING AND OPERATION FOR BLOWER FUNCTION
1. Connect the blow tube to the blower air outlet:
Line up the pegs(1) on the inside of the blow tube(3) with the notches(2) of the
housing opening as shown in below picture, make sure the installation is firm.
(1) Pegs of White Ring (2) Notches of Air Outlet （3）Blow Tube
2. Install the battery to the blower:
Insert battery pack into tool until an audible click is heard as shown in picture.
Make sure battery pack is fully seated and fully latched into position.
3. Press the trigger switch to start blowing and control the blower power.
To Next Page
Loading...