QUICK START GUIDE
Kinesis
®
Savant Elite2™ Module & Pedal with
SmartSet Cong App, Model FP10J
22030 20th Avenue SE, Suite 102, Bothell, Washington 98021 USA
sales@kinesis.com, 800-454-6374, www.kinesis.com
DEFAULT CONFIGURATION
Your Savant Elite2 Module & Pedal comes with your choice of two factory-programmed actions:
To use your Savant Elite2 Module & Pedal with one of the factory-programmed actions:
1. Connect the pedal to Control Module using the jack of your choice.
2. Plug the Module’s USB cable into your computer.
3. The red LED on the Module will illuminate and a device installation notice will appear.
4. When the green LED illuminates, the device is ready to use with that pre-programmed action.
5. To switch actions, simply connect the pedal to the other jack.
© 2016 by Kinesis Corporation, all rights reserved. Printed in the USA on recycled paper. KINESIS is a registered trademark of Kinesis Corporation. SAVANT ELITE2, V-DRIVE, SE2, and SMARTSET are
trademarks of Kinesis Corporation. WINDOWS, MAC, and ANDROID are registered trademarks of Microsoft Corporation, Apple, Inc., and Google, Inc., respectively.
Jack 1
Left Mouse Button
Single Click
Jack 2
Right Mouse Button
Single Click
Pedal
with
mini-phono
plug
Control Module
Foot Pedal
There is no software or special drivers to install — all you need is a USB port. The Savant Elite2
works with Windows, Mac, Android, and Linux. SmartSet Cong App versions are onboard for
graphical programming in Windows & OSX. Visit the SE2 Resources page for full User’s Manual
including how to program in Android and Linux: www.kinesis.com/savant-elite2-resources/.
LANGUAGE NOTE: You must use U.S. English keyboard driver when re-programming your device,
then switch back to your normal language.
To Next Page
Need help?
General
