Need help?Do you have a question about the King Canada 8514GT and is the answer not in the manual?
General| Shaft Type | Straight |
|---|---|
| Line Diameter | 0.080 inches |
| Engine Type | 2-Stroke |
| Fuel Tank Capacity | 450 ml |
| Cutting System | Bump Feed Head |
Keep your dated proof of purchase for warranty and servicing purposes.
Replacement parts are available at authorized King Canada service centers.
Details the 2-year limited warranty for defects in materials and workmanship.
Manual is a guide; specifications subject to change without notice.
Refer to website for updated parts diagram and list.
Read manual and labels; understand applications, limitations, and hazards.
Keep area clean, well-lit, and avoid dangerous environments like damp locations.
Use proper gauge extension cords and recommended accessories.
Wear proper apparel, safety glasses, and maintain footing and balance.
Disconnect tool before servicing, avoid accidental starting, check parts.
Identifies on/off switch, control handle, lock knob, and angle adjustments.
Covers telescopic shaft, height adjuster, and foldable edge guide.
Details the cutting line, spool, and line feed button.
Explains the power cord, safety guard, and extension cord lock.
Requires 110-120V operation with a 15-AMP time delay fuse or circuit breaker.
Use with a suitable polarized 2 or 3 wire extension cord for shock prevention.
Use heavy-gauge, outdoor-rated cords; replace damaged cords immediately.
Secure cord to lock system to prevent accidental unplugging during use.
Attach control handle to handle hub using locking bolt and knob.
Align and turn safety guard clockwise to lock onto motor housing.
Loosen adjuster, move handle to set length, tighten adjuster to secure.
Press head swivel button and rotate handle/shaft 180 degrees.
Squeeze buttons to adjust head angle to one of four predetermined positions.
Intended for cutting dry grass; follow safety instructions before operation.
Use edge guide to protect objects; guide wheel aids edging along surfaces.
Automatic feed lengthens line when trigger released; manual feed extends line.
Use only specified replacement spools (KW-135) and follow installation steps.
Connect cord, squeeze trigger to start; release trigger to stop.
Hold with two hands, use sweeping motion, reduce load if running slowly.
Turn off and unplug; clean with mild soap and damp cloth; store indoors.
Addresses slow running and automatic line-feed problems.
To Next Page