Why does my King Canada sander slow down during operation?
If your King Canada sander slows down while you're working, it's likely because you're pressing down too hard on the material. Try using less pressure to see if that solves the problem.
Why does the motor on my King Canada KC-760L overheat?
If the motor of your King Canada sander overheats, it could be due to a motor overload. Try reducing the load on the circuit. Another possible cause is an overtensioned drive V-belt. In this case, you should retension the V-belt properly.
What to do if my King Canada KC-760L Sander motor chokes?
If the motor of your King Canada sander chokes, causing a burnt fuse or tripped circuit breaker, it could be due to a short-circuited motor or a bad connection; check all motor connections and wire insulation. Another cause could be low voltage; try to rectify the voltage. An incompatible fuse or circuit breaker in the electrical box can also cause this issue; install the appropriate fuses and circuit breakers. Lastly, the motor might be overloaded, so reduce the charge on the circuit.
What to do if my King Canada KC-760L Sander motor doesn’t start and the fuse is burnt?
If your King Canada sander motor doesn't start, and the fuse is burnt or the circuit breaker is tripped, there are a few potential causes. It could be a short circuit in the plug or switch; check these for bad insulation or contact. Alternatively, there might be a short circuit or bad connection in the motor; inspect all motor connections for bad wire insulation. Lastly, the electric box might have an incompatible fuse or circuit breaker; install the proper fuse or circuit breaker.
General| Brand | King Canada |
|---|---|
| Model | KC-760L |
| Category | Sander |
| Language | English |
To Next Page
