Need help?Do you have a question about the King gates Star 2230 and is the answer not in the manual?
General| Brand | King gates |
|---|---|
| Model | Star 2230 |
| Category | Control Unit |
| Language | English |
Provides an overview of the control board's features and connections.
Details the steps required to start the gate automation system.
Lists the key functionalities and capabilities of the control unit.
Provides technical specifications like voltage, power, and temperature range.
Explains the default settings for standard programming procedures.
Specifies the required cable sizes and types for power and low-tension connections.
Illustrates the terminal connections for motors, safety devices, and accessories.
Guides on how to program the START function for radio transmitters.
Guides on how to program the pedestrian opening function for radio transmitters.
Explains the procedure to remove all stored radio remote control codes.
Details the function and settings of each dip-switch on the control unit.
Explains how to adjust the trimmer settings for power, obstacle sensitivity, and pause time.
Detailed explanation for each of the 8 dip-switches (RADIO, FAST, STRIKE, LAMP, PHO2, AUTO, STEP, SLOW).
Important warnings and notes before performing the travel programming procedure.
Step-by-step guide for the standard procedure to set motor manoeuvre times.
Procedure to set custom slowdown points for opening and closing cycles.
Procedure to set a partial opening (pedestrian) for the gate.
Procedure to remove the programmed pedestrian opening settings.
Adjusts motor power and speed, requiring reprogramming after changes.
Sets the pause time before automatic reclosing when DIP AUTO is ON.
Adjusts obstacle detection sensitivity and opposing force during operation.
Sets the delay between the start of the motors for opening and closing.
Explains the status indicated by the various LEDs on the control unit.
Details how to connect external switches or selectors for starting the automation.
Explains how to wire external contacts for pedestrian opening commands.
Describes how to connect an external stop button for immediate function halting.
Details the operation of safety devices connected to the PHO1 input during closing.
Details the operation of safety devices connected to the PHO2 input during opening/closing.
Explains the self-test function for safety devices and how to activate/deactivate it.
Explains how obstacle detection works based on motor power absorption.
To Next Page
