Need help?Do you have a question about the King gates Star D1230 and is the answer not in the manual?
General| Brand | King gates |
|---|---|
| Model | Star D1230 |
| Category | Control Unit |
| Language | English |
Explains the general features and components of the control unit, including signaling LEDs, dip-switches, and trimmers.
Specifies the required cable types and sections for connecting the control unit and accessories.
Illustrates the wiring diagram for connecting power supply, motors, and accessories to the control unit.
Step-by-step guide to program radio transmitters for the main gate opening command.
Procedure to program radio transmitters for pedestrian gate opening.
Instructions on how to erase all previously programmed radio remote controls from the unit.
Details the function of each DIP-switch for configuring the control unit's behavior.
Explains how to adjust trimmers for power, obstacle sensitivity, pause time, and prelamp duration.
Defines the behavior of safety devices in opening and closing cycles.
Configures the control unit for step-by-step or open/stop/closing operation.
Important precautions to take before and during the gate travel programming procedure.
Step-by-step guide for the standard procedure to set the gate's travel limits and motor force.
Procedure to set a partial opening (pedestrian) for the gate.
How to remove the programmed pedestrian opening settings.
Explains the meaning of various LEDs on the control unit, indicating status and errors.
Details how to connect external wired commands for starting the gate automation.
Explains how to connect wired commands for pedestrian opening.
Describes how to connect wired commands for stopping the gate automation.
How closing safety devices (like photocells) operate and are connected.
How opening safety devices operate and are connected, depending on DIP switch settings.
Procedure for activating and deactivating the safety auto-test function.
Explains how obstacle detection works via motor power absorption and trimmer adjustment.
How to connect and configure a flashing lamp accessory.
Guidance on connecting an external antenna to improve radio reception.
How the warning light functions and its connection for gate status indication.
Troubleshooting steps when the gate automation fails to start.
Diagnosing why the automation only performs the opening cycle.
Troubleshooting when the automation only responds to wired commands, not radio.
Resolving issues where the automation closes unexpectedly.
Troubleshooting travel inversion issues, possibly related to sensitivity or safety devices.
Diagnosing why the automation stops prematurely during operation.
Troubleshooting immediate stops upon starting, possibly due to encoder or autotest.
Resolving issues where the motor fails to perform slowdowns.
Troubleshooting error LED indications and input acceptance issues.
To Next Page
