MAINTENANCE
1). Periodically check and maintain proper gear oil level.
2). Every 8 hours, wheel fork (s), wheel hub (s), PTO shaft universal joints (2), and
PTO telescoping surface. (See Figures M-1 & M-2)
NOTE: Use only a grade Type II tube grease.
3). Before each use check to make sure all safety features are installed and work-
ing properly.
4). Keep blades sharp and balanced at all times. When replacing blades, replace
all blades and blade bolts at the same time.
5). Periodically check all nuts and bolts to insure they are tight and secure.
22
Figure M-1
(grease points
Figure M-2
(U-joints)
To Next Page
Loading...
