MAINTENANCE
1). Periodically check and maintain proper gear oil level.
2). Every 8 hours, wheel fork(s), wheel hub(s), PTO shaft universal
joints (2), and PTO telescoping surface. (See Figures M-1 & M-2)
NOTE: Use only a grade Type II tube grease.
3). Before each use check to make sure all safety features are in-
stalled and working properly.
4). Keep blades sharp and balanced at all times. When replacing
blades, replace all blades and blade bolts at the same time.
5). Periodically check all nuts and bolts to insure they are tight and
secure.
22
Figure M-1
(grease points at arrows)
Figure M-2
(U-joints)
To Next Page
Loading...
