USSC 76 USSC
Installation
CLEARANCES
NOTE: Distance on the left-hand side of your Multi-Fuel Furnace!""#$%$&!'()#"*+,".!$%/0#%((#""$+
$)#(+'$,+01%'#0%'2*+,*.#00+%2!'3)!"2!"$%'(#4%5/#0#""/.$'+$0#""$)%'!'()#"
INSTALLATION OPTIONS
Read this entire manual before you install and use your Multi-Fuel Furnace. Failure to follow instructions
may result in property damage, bodily injury, or even death!
or Mobile Home.
As a Primary Furnace
when the plenum and exhaust temperatures reach a preset point programmed into the furnace’s circuit board (PCB). Unit
As a —the unit aids an existing gas/electric furnace helping cut down on operation time.
Ì
Installation
IMPROPER INSTALLATION: The manufacturer will not be held responsible for damage caused by the mal-
function of a furnace due to improper venting or installation. Call (800) 750-2723 and/or consult a professional
installer if you have any questions.
FLOOR PROTECTION
non-combustible surface should be large enough to extend a minimum
of 6-inches in front, 6-inches on each side, and 1-inch behind the
furnace for horizontal termination.
Floor protection must extend under and 2-inches to each side of the
chimney tee for an interior vertical termination.
A 1 inch thick Floor Protector is recommended with installation.
ADDITIONAL ITEMS REQUIRED FOR INSTALLATION
tightly constructed room.
To Next Page
Loading...