The hearth on which the stove is to be placed should not be less than 125mm thick
and should be in accordance with the current building regulations.
Care should be taken to level the stove using the adjusting screws in the feet.
The appliance shall be installed on floors with an adequate load-bearing capacity. If
an existing construction doesn’t meet this prerequisite, suitable measures (e.g. load
distributing plate) shall be taken to achieve it.
There should be no combustible material within a distance of 500mm from any
surface of the stove
Commissioning and Handover
You should leave an appropriate period of time for fire cement and mortar to dry
out upon completion of the installation. In order to ensure the smoke and fumes are
taken from the stove up the chimney and emitted safely to atmosphere, a small fire
should be lit first. Do not run the stove at full output for at least 24hours.
Finishing installation and commissioning, the operating instructions and tools for
your stoves should be kept in hand. It is also important to know how to use the
stove properly and use only the recommended fuels for this appliance. The user
should know how to have smoke or fumes emitted properly from the stove and be
warned to prevent injuries in case of the presence of children, aged or infirm
persons.
Operating Instructions
WARNINGS AND IMPORTANT!
All local regulations, including those referring to national and European
Standards need to be complied with when installing the appliance.
This appliance is not suitable for installation in a shared flue system.
The firebox and ashpit cover shall be kept closed except during ignition,
refueling and removal of residue material to prevent fume spillage.
It is important to use this appliance correctly so as to achieve best results.
WARNING!(Boiler Model Only)
Ensure that there is enough water in the heating system.
Do not light the fire if it is suspected that any part of the water system is
frozen.
Air Controls
Warning! Parts of the appliance, especially the external surfaces, will be hot to
touch when in operation and due care need to be taken, e.g. protective gloves
should be given in operation.
It is essential for the appliance to have a sufficient air supply for combustion and
ventilation.
To Next Page
Loading...