Kingfisher DDD500WT151DA - Page 17

16 17
Quick start
OPEN WINDOW
 Thisfunctionswitchesautomaticallytofrostprotectionmodewhenanopen
window is detected and returns to the initial mode when the window is
closed.
- Press MENU, then + to access the Und menu.
- Press OK-boost to enter this menu.
- Press + or – to permanently activate the function
(Aut), or to activate it once (ΠAn) or to deactivate
it (OFF).
- Press OK-boost to validate.
 Themanualposition(ΠAn)putstheheaterintofrostprotectionmodefor
one hour. During this hour, the initial settings can be re-established by
pressingMENU.
The iconasheswhenitdetectsanopenwindow.
 Whenanopenwindowisdetected,theheaterheatsforafewminutesevery
halfhourtocheckwhetherthewindowisclosed.
Importanttonote:
- The sensor in theheater detectswhether a window is openor closed
bymeasuringabnormaltemperaturevariations.Detectioniscarriedout
severalminutesafterthewindowisopenedorclosed.
-Detectionmaybeineectiveifthesetemperaturevariationsareinsu-
cientoruntimely.Thisisthecasewhere:
-Thedierencebetweentheindoorandoutdoortemperatureisinsucient.
-Theheateristoofarfromthewindow.
-Thetemperaturegradientintheroomdoesnotallowforsignicanttem-
peraturevariationsintheheatersensor.
-Theambienttemperatureisnotstabilisedatleast onehourbeforethe
windowisopened.
-Thetemperature settingormodeweremodiedmanuallyorbyapro-
grammebeforeorduringdetection.
DISPLAY OF REFERENCES
Thismenudisplaystheequipmentandsoftwarereferences.
- Press MENU , then + to access the references; the reference for the equip-
ment and the reference for the software are displayed alternately.
- Press MENU to exit the menu.
Quick start