34
EN
In more detail...
FPCSP41-3
Product functions
Intended use
This petrol chain saw FPCSP41-3 is designated with a power output of 1.4 kW.
The product is intended for cutting logs and limbs with a thickness of max.
350 mm.
It must not be used for cutting other materials, such as plastic, stone, metal,
wood that contains foreign objects, or materials that are harmful to health. This
product should not be used outside of domestic premises e.g. for cutting rewood
in forested areas.
The product may only be used with the guide bar/saw chain combination stated
within these instructions. The use of other types or sizes is not allowed.
With this product vertical and horizontal cuts can be performed. Longitudinal
sections may only be cut by professionals.
For safety reasons it is essential to read the entire instruction manual before rst
operation and to observe all the instructions therein.
This product is intended for private domestic use only, not for any commercial
trade use. It must not be used for any purposes other than those described.
Primer
Press the primer (4) 6 times when starting the
product with a cold engine (Fig. 20). Do not
press the primer for warm starts.
4
Fig. 20
Choke lever
1. By pulling out the choke lever (5) fully (Fig. 21a), the choke is now at CLOSE
position, and the throttle is at fast tickover.
2. By pressing in the choke lever (5) (Fig. 21b), the choke is now at OPEN
position while the throttle is kept at fast tickover.
3. To cancel fast tickover, press and release the throttle interlock (2) and throttle
trigger (3).
MNL_Petrol Chainsaw_FPCSP41-3_GB_V02_220301.indd 34 3/2/22 11:35 AM
To Next Page
Loading...