Need help?Do you have a question about the Kingship JDW Series and is the answer not in the manual?
When LCD shows '-----', it means OVERLOAD. Remove measured objects immediately.
Please assemble the platter before powering on the scale.
Do not keep the weight placed on the platter for a long period.
Keep the scale away from environments with high temperatures, humidity, heavy pressure, and bump.
Make sure the scale is located on a flat and plane surface.
Scale Body: 285 x 285 x 110 (mm)
Platter: 192 x 275 (mm)
'O' appears on the left-bottom corner of LCD, and indicates the scale is at zero-point.
'Net' appears on the bottom edge of LCD, indicating the tare weight has been deducted.
Battery symbol appears on bottom edge of LCD, indicating low-voltage status.
AC: 110V or 220V ±10% 50/60 Hz
DC: 6V/25mA Rechargeable Battery; P=0.2W(max)
Select the weighing mode (kg or g / pcs).
Instructions for setting quantity using the simple counting function.
Pressing ZERO key to zero light weights or get net weight.
Deduct tare weight of container/package and recall it.
Deduct tare weight and obtain net/gross weight.
Press and hold [ZERO] key on power on to view firmware version.
Press and hold [UNIT] key until 'SETUP' is displayed.
Press [UNIT] to cycle through USUAL 1-3, press [TARE] to enter.
Options include AD Value, Backlight, and UNIT Setting.
Power on while holding [ZERO], then [UNIT] to enter SETUP, then [ZERO] for CAL-1.
Use [TARE] to shift digits and [UNIT] to modify them. Confirm with [ZERO].
Place standard weight, press [ZERO] to confirm, scale will flash 'good'.
To Next Page
General