KingTone Switch User Manual (English)

To Next Page

VOLUME POT

White

Red

Black

Add the White, Red and Black wires to the volume pot as shown.

KINGTONE SWITCH INSTALLATION

1. Solder the Kingtone Switch as shown in the diagram.

2. Reassemble the guitar, but leave the Kingtone switch on the outside of the guitar.

5. Remove plastic protector tape from the slide switch.

4. Make adjustments to the treble bleed settings until you’re happy.

5. Open the guitar back up and tightly install the Kingtone Switch with washer and nut.

If installing the Kingtone Switch on a Strat guitar, we recommend using the remaining tone

pot to control either all pickups or just the middle and neck.

Use the wire taken from the middle leg of the old tone control and add

it to the remaining tone control’s middle leg and solder in place.

PLEASE CHECK OUT THE KINGTONE SWITCH INSTALLATION VIDEOS

www.kingtoneguitar.com/instructions

Install The Kingtone Switch As Follows

Need help?

Do you have a question about the KingTone Switch and is the answer not in the manual?

KingTone Switch Specifications

General

Bypass	True Bypass
Power	9V DC
Input	1/4" Jack
Output	1/4" Jack
Controls	Tone
Power Supply	External 9V DC power supply (center negative)

Detailed steps for soldering, reassembly, and connecting the Kingtone Switch to the volume pot.