KINKI STUDIO
5
CONTROLS
控制
6
>+ 7%"#$%3
Power Up
The power inlet IEC of the EX-M7 is located at the rear panel. After the power is supplied to the
amplifier, it will be in Start-up state. The display will indicate WAIT and Orange LED blinks for 5s.
Thereafter, the amplifier will be in Standby state, where the display indicates STANDBY and Orange
LED stop blinking.
To power up, press on the Power Button once, the soft-starter circuit in the EX-M7 engaged,
display indicates OPERATION and Green LED light up after a short delay, the amplifier will be in
Operational state.
Fault
Should the display FAULT and Red LED light up, it signify the amplifier is in Fault state. Please turn it
off and confirm all connection correctness. Should the fault persisted, please contact our sales
support.
To Next Page
Loading...
