EasyManua.ls Logo

Kinroad XT50QT-2 - Rules for Safe Drive; Do Not Overload; Modification

Kinroad XT50QT-2
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 3 -
RULES FOR SAFE DRIVE
Check must be conducted before starting the engine to
prevent mishaps and damage to components.
Only the qualified person who has passed the drive
examination with a drive license is permitted to drive the
vehicle but not anybody else without a drive license.
Full preoccupation is required during drive, paying
attention to the following points to avoid any possible
hurt
to you by other motorized vehicles:
Do not drive too close to other vehicles;
Never contend for lane.
Strictly observe the local traffic rules.
As driving at overspeed is the cause of many accidents.
Do not drive at a speed that the actual situation does not
permit.
Particular care should be exercised at the level
crossing of roads, entrance and exit of parking lot or on
the automobile lane.
During drive, grasp the left handlebar by the left hand
and the throttle twist grip by the right hand, with feet on
the footrests.
MODIFICATION
any modification of the motorcycle or removal of the
original equipment may render the vehicle unsafe or illegal
P1ease obey all the national and local equipment
regulations.
DO NOT OVERLOAD
1. Do not load on the places where they are not allowed.
2.Do not put cotton or other same items near the engine
or the exhaust pipe, When the motorcycle is in the
over-loading condition, its stability, security and speed
will be affected.

Related product manuals