Why is oil leaking from my KINSHOFER Industrial Equipment?
Oil leaks in KINSHOFER Industrial Equipment can occur due to: * Loose screwed connections (fittings). Solution: Tighten or reseal them. * Leaking hydraulic quick release couplings. Solution: Check, seal, or replace the couplings.
What to do if the KINSHOFER KM 506 HD quick coupler does not disengage?
If the quick coupler on your KINSHOFER Industrial Equipment fails to disengage, consider these potential causes and solutions: * The crane might not be fully relieved of the attachment's weight. Lower the crane slightly to set down the attachment. * Hydraulic quick release couplings may be under pressure. Ensure that the pressure release has been carried out properly. * The working pressure for unlocking could be too low. Increase the pressure limit on the control block.
How to fix a KINSHOFER KM 506 HD Industrial Equipment quick coupler that does not engage?
If the quick coupler on your KINSHOFER Industrial Equipment is not engaging, check the following: * Ensure the upper and lower parts are properly aligned by making straight vertical movements with the crane. * Inspect and remove any foreign matter (such as metal parts or debris) that may be preventing complete engagement. * Check the safety catches; they may not be engaging properly or could be too tight. Inspect, loosen, and remedy as needed.
What to do if grab’s functions are reversed on my KINSHOFER Industrial Equipment?
If the grab's functions are reversed on your KINSHOFER Industrial Equipment, it could be because the upper or lower part was turned 180° in the locked position. To correct this, unlock, turn the upper part (rotator shaft) 180°, and then lock it back in place.
General| Brand | KINSHOFER |
|---|---|
| Model | KM 506 HD |
| Category | Industrial Equipment |
| Language | English |
To Next Page