S41O510A
JUMP STARTING
(1) Dead Battery (2) Jumper Cables
(3) Helper Battery
7. If the helper battery is in another ve-
hicle, do not allow the tractor and
the other vehicle to touch. Start the
vehicle’s engine after connecting
the cables and let it run for a few
moments. Turn off all accessories
on both vehicles. Then start the dis-
abled tractor.
8. Disconnect the battery cables in the
exact opposite order as they were
attached.
When jump starting the engine, follow
the instructions below to safely start
the engine.
1. Use a battery of the same voltage
as the disabled tractor to jump start
the tractor. Locate the good battery
in a safe place where the jumper ca-
bles will reach.
2. Engage the parking brake of the
tractor and shift the transmission
gear to neutral position.
3. Put on safety goggles and rubber
gloves.
4. Place the battery hole caps to prop-
er position.
5. Attach the red clamp to the positive
terminal of the dead battery, and at-
tach the other end to the positive
terminal of the helper battery.
6. Clamp the black cable to the Engine
hooks, and attach the other end to
the negative cable of the helper bat-
tery.
Keep fire, spark, cigarette,
etc., away from the battery.
When the tractor battery is
frozen, jump starting of the
engine is prohibited.
Do not connect the (-) jumper
cable to the negative(-) termi-
nal of the discharged battery.
CAUTION
To Next Page
Loading...
