kioxia EXCERIA User Manual (English)

To Next Page

1/30

Please be sure to check personal.kioxia.com/support/ for the latest rmware

updates.

SAFETY INSTRUCTIONS

Please refer to “Instruction Manual for Safety and Comfort”:

personal.kioxia.com/support/

Note: The following instructions are a general guideline for the SSD installation

and should act as a complement to your system’s owner manual.

LAPTOP INSTALLATION

1. Power o the system, disconnect all power cables, and remove the battery.

2. Locate the hard drive access panel; unscrew and remove the access panel.

3. Disconnect and remove the current storage drive from the drive bay

(refer to your system’s user manual)

4. Remove all brackets and connectors from your current storage drive and

install it on the SSD (if necessary).

Note: If a proprietary connector and/or bracket are present on the current

storage drive, carefully remove it and connect it to the SSD. Systems will

vary and these items may or may not be present.

5. Insert the SSD into the drive bay carefully aligning the SSD with the SATA*

connectors.

6. Secure the SSD in the drive bay. Reinstall the access panel and insert the

battery back into the system.

7. Power on your system to verify a successful installation. For a boot drive,

this is signied by the BIOS prompting OS installation. For a secondary

drive, follow the format instructions below.

Note: If the SSD will be your primary boot drive, please refer to your

operating system’s user manual for further OS installation instructions. If

this SSD will be used as a secondary drive, formatting the drive is required

before use.

*SATA 6Gbit/s is backwards compatible with SATA 3Gbit/s. However,

connecting a SATA 6Gbit/s device into a SATA 3Gbit/s connection will

result in reduced performance.

SATA SSD

Quick Start Guide

TC000G0

Need help?

Do you have a question about the kioxia EXCERIA and is the answer not in the manual?

kioxia EXCERIA Specifications

General

NVMe	No
Interface	Serial ATA III
Read speed	555 MB/s
TBW rating	60
Memory type	TLC 3D NAND
Write speed	540 MB/s
SSD capacity	240 GB
Component for	Laptop
SSD form factor	2.5\
Random read (4KB)	79000 IOPS
Data transfer rate	6 Gbit/s
Random write (4KB)	87000 IOPS
DevSlp (device sleep) support	Yes
Mean time between failures (MTBF)	1500000 h
Operating voltage	5 V
Power consumption (average)	1.6 W
Operating shock	1500 G
Operating vibration	20 G
Storage temperature (T-T)	-40 - 85 °C
Operating temperature (T-T)	0 - 65 °C
Harmonized System (HS) code	84717070