C. Ignition system
■ Fill in oil to the demanded level.
■ Use the genuine spark plug A7RTC.
■ Spark plug inspection
1. Disassemble spark plug
2. Install spark plug onto spark plug cap.
3. Set the oil switch to the “ON” position. Ground the negative (—) electrode (i.e. threaded part) of the
spark plug against the shroud and pull the recoil starter rope to check the spark plug.
■ Don’t pull the recoil starter while touching the high tension wire with wet hands. High voltage
generates, which is very dangerous.
■ Drain the gasoline from the fuel tank and carburetor.
■ Pull the recoil starter several times to release the unborn gas in the cylinder with the engine switch
OFF.
12
To Next Page
Loading...
Need help?
General
