SAFETY NOTES
2.0
2.1 SAFETY REGULATIONS
2.1.1 A licensed driver should operate the machine
2.1.2 If any trouble occurs due to overload or sudden resistance (large stones), stop
the tractor immediately and take out the Cardan shaft. Lift the Univator, detect the
cause and remove the solid bodies. Be sure, there is no damage in working parts and
continue the work.
2.1.3 The angle formed by the P.T.O. shaft centreline and the centreline of the Cardan axle
should never exceed 30 Degree.
2.1.4 All servicing and maintenance operations must be performed only at rest, with tractor
switched off.
2.1.5 Do not try to take turns with the blades in contact with the ground. Before turning, lift
the Univator in transport position.
2.1.6 Do not get under the machine when it is in transport position.
2.1.7 Do not operate the machine or allow anyone to come near machine when under
influence of intoxicants like alcohol etc.
2.2 SAFETY INSTRUCTIONS
Read the Operation &
Maintenance manual
Before using the machine
Danger to hand and fingers
due to collision with parts in
rotation.
Keep the safe distance
Danger to feet due to
Collision with parts in
Rotation. Keep the safe
distance
Danger to feet due to
rotating cutters.
Keep the safe distance
Danger due to machine
Component that is Lifted
above the ground. Keep the
safe distance
Danger of cutting due to
moving parts. Wait until all
moving components are
completely motionless before
approaching the machine.
Danger due to
flying objects.
Keep the safe
distance
Danger to hot surface.
Keep the safety
Distance
Danger of hand and
finger cutting.
Keep the safe
distance.
Danger of feet
cutting Maintain
the safety distance
Danger of rotating
movements. Do not open
or remove the safetyguards
of the rotating shafts while
the machine is
Danger due to loads lifted
from the ground. Keep the
safety distance
11
To Next Page
Loading...
