6) Strictly comply with all the recommended accident preventing measures described
in this booklet.
7) Assembly of an implement on the tractor will shift the weights on the axles. It is
therefore advisable to add weights to the front part of the tractor in order to balance
the weights on the axles themselves.
8) The coupled implement may only be controlled through the Cardan shaft complete
with the necessary safety devices for overloads and with the guards fixed with the
relative latch. Keep away from the Cardan shaft while it is turning.
9) Before starting the tractor and implement, always check that all safety devices,
guarding transports and use are in a perfect condition.
10) The instruction labels affixed to the machine give useful advice on how to prevent
accidents.
11) Always comply with the Highway Code in force in your country when traveling on
public roads.
12) Transport on roads takes place under the total responsibility of the user, who is
obliged to verify the adequacy of the machine to the rules of the road traffic code in
force in that country.
13) Comply with the maximum permissible weight on the axle of the tractor, the total
adjustable weight, shipping regulations and the Highway Code.
14) Always become familiar with the controls and their operation before starting work.
15) Always wear suitable clothing. Never ever wear loose garments or those with edges
that could in some way become caught up in rotating components or moving
mechanisms.
16) As indicated, couple the implement to a tractor of equal power and configuration,
applying a device (lift), confirming to the prescriptions.
17) Take the utmost care during the implement coupling and release phases.
18) Any accessories for transport must be equipped with adequate signals and guards.
19) Never ever leave the driving seat while the tractor is moving.
20) It is very important to remember that the road holding, steering and braking capacity
may be even notably influenced by the presence of a towed or mounted implement.
21) Always take care of the centrifugal force exercised by the furthered position of the
center of gravity, when turning corners with the implement mounted.
1) Side guard
2) 3- point coupling
bearing frame.
3) Tilt adjusting road.
4) Cardan shaft.
5) Tractor pto coupling.
6) Lower tractor coupling
links.
Image: B
SAFETY NOTES
2.0
13
To Next Page
Loading...
