5.0
TROUBLE SHOOTING
Sr. No.
Trouble
Possible Causes
Remedy
Excessive noise
Loose joints.
Play in 3P Hitch Hole & Pin.
Residues or deposits in the
Hoes/Blades or on the rotor
Check all joints & tighten properly.
Check 3P Hitch & Pin for proper
clearance, correct/replace accordingly.
Clean the residue.
7.
Excessive
Vibration
Loose Fasteners Tighten Fasteners properly.
8.
Worn out Hoes/Blades. Replace the worn out Hoes/Blades
by new.
If the problem continues, contact Dealer.
Poor
Pulverization
Bonnet is more open
Set bonnet to an appropriate position
9.
Machine is not properly
aligned/set w.r.t. Land
& Tractor
Refer manual for machine
setting/consult the service personnel.
Low rotor speed.
Increase machine speed by change
gears in respect of land. Ensure
tractor PTO is at rated RPM.
Worn out/Bend Blades.
Replace with new genuine Hoes/Blades.
Wet Soil
Reduce machine speed.
Excess Load
on Tractor
10.
High Tillage depth Use appropriate depth in respect
of soil condition.
Clogging of soil in
rotor blades.
Worn Out & bend blades are to be
replaced by new genuine blades.
Incorrect orientation of
blades on rotor.
Refer machine manual.
Oversize of Machine in
respect of tractor.
Use right machine size as
recommended.
Hard Soil
Use appropriate depth in
respect of soil condition.
Clogging of soil in rotor
& mainframe.
Open bonnet.
If the problem continues, contact Dealer.
Worn out & Bend Blades Worn Out & bend blades are to be
replaced by new genuine blades.
Clogging of Soil
in rotor blades
11.
Wet Soil Open bonnet.Clogging of soil
in rotor
12.
24
To Next Page
Loading...
