KitchenAid 5KEK1565 - Using the Electric Kettle; Operating the Electric Kettle

12 | USING THE ELECTRIC KETTLE
USING THE ELECTRIC KETTLE
OPERATING THE ELECTRIC KETTLE
Before using your Electric Kettle for the rst time, wash the Kettle and lid in hot, soapy water,
then rinse with clean water and dry. Fill the Electric Kettle with water to the MAX ll line; boil
the water and then discard. To avoid damage, do not fully immerse the Electric Kettle in water,
and do not use abrasive cleaners or scouring pads.
1
Open the lid of the Electric Kettle by pressing the lid
release button, then ll the Electric Kettle with clean,
cold water
NOTE: Water must be at or above the MIN fill line for the Electric Kettle to operate. Do not
exceed the MAX fill line.
2
Push the lid down so that it is completely closed.
WARNING
Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove an earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, re,
or electrical shock.
3
Place the Electric Kettle on the base, and plug the
power cord into an earthed outlet.
4
Flip the on/off switch down; the On indicator will light
and the Electric Kettle will begin heating the water.
W11222482 - New Final Copy.indb 12 25/06/2018 20:56:08