EN
5
PRODUCT SAFETY (CONTINUED)
ELECTRICAL REQUIREMENTS
WARNING
Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or electrical
shock.
Voltage: 220-240 VAC
Frequency: 50-60 Hz
Power: 1470 Watts
NOTE: If the plug does not fit in the outlet,
contact a qualified electrician or service
person. Do not modify the plug in any way. Do
not use an adapter.
Do not use an extension cord. If the power
supply cord is too short, have a qualified
electrician or service person to install an outlet
near the appliance.
The cord should be arranged so that it will not
drape over the countertop or tabletop where it
can be pulled on by children or tripped over
unintentionally.
GETTING STARTED
First, clean all parts and accessories (See “Care and Cleaning” section).
Place the Espresso Machine on a dry, flat, level surface such as a countertop or table.
1. Fill the Water Tank with fresh water (max. 1.4 Litre). Replace the Water Tank Lid.
2. Insert the Steam Wand until you hear a click.
IMPORTANT: Distilled water or mineral water can damage the Espresso Machine. Do not use
either to brew espresso.
WARNING
Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
3.
Plug into an earthed outlet. Press the main power switch to “- (on)”.
4. The machine automatically pumps water into the heater and starts heating. When lights
stop blinking, the Espresso Machine is ready for use.
To Next Page
Loading...
