EN
7
PRODUCT ASSEMBLY (CONTINUED)
3. Install the Blade on top of the Dicing Disc by sliding it onto the Drive Pin.
A. Drive Pin
4. Install the Lid by turning counterclockwise, being sure it locks into place.
ATTACHING THE FOOD PROCESSOR ATTACHMENT TO THE
STAND MIXER
1. Turn Stand Mixer OFF(0) and unplug.
2. For Stand Mixers with a hinged attachment hub cover: Flip up to open.
For Stand Mixers with a removable attachment hub cover: Turn the attachment knob
counterclockwise to remove attachment hub cover.
3. Insert the Attachment into the attachment hub. Rotate the Attachment back and forth if
necessary. The pin on the attachment housing will fit into the notch of the hub rim when in
its proper position.
4. Tighten attachment knob until the Food Processor Attachment is completely secured to
the Stand Mixer.
5. Place a bowl or container under the food exit chute.
WARNING
Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
6.
Plug the Stand Mixer into an earthed outlet.
To Next Page
Loading...
