KitchenAid 5KSM5 - Page 5

TO LOCK MOTOR HEAD IN RAISED
POSITION
• Push locking lever up into UNLOCK
position and hold.
•Tilt motor head back.
• Move locking lever into LOCK position.
TO LOCK MOTOR HEAD IN
OPERATING POSITION
• Push locking lever up into UNLOCK
position and hold.
• Lower motor head until it is completely
down into operating position.
• Move locking lever into LOCK position.
• Before mixing, test motor lock by
attempting to raise head.
NOTE: Motor head should always be kept
in LOCK position when using mixer.
TO OPERATE CONTROL SPEED
• Speed control lever should always be set
on lowest speed for starting, then
gradually moved to desired higher speed
to avoid splashing ingredients out of
bowl.
See page 9 for Speed Control Guide.
Solid State Speed Control
Off Stir 2 4 6 8 10
English
R-5
TO ATTACH BOWL
• Be sure speed control is OFF.
• Hold the locking lever in the UNLOCK
position and tilt motor head back.
• Place bowl on bowl-clamping plate.
•Turn bowl gently in clockwise direction.
TO REMOVE BOWL
•Turn speed control OFF.
• Holding the locking lever in the
UNLOCK position and tilt motor head
back.
•Turn bowl in counterclockwise direction.
TO ATTACH FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
•Turn speed control to OFF and unplug.
• Hold the locking lever in the UNLOCK
position and raise motor head.
• Slip beater onto beater shaft and press
upward as far as possible.
•Turn beater to right, hooking beater over
pin on shaft.
TO REMOVE FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
•Turn speed control to OFF and unplug.
• Hold the locking lever in the UNLOCK
position and raise motor head.
•Press beater upward as far as possible
and turn left.
• Pull beater from beater shaft.
C
A
U
T
I
O
N
:
U
n
p
l
u
g
b
e
K
i
t
c
h
e
n
A
i
d
S
t
.
J
o
s
e
p
h
,
M
i
c
h
i
g
a
n
U
S
A
O
ff
S
ti
r
2
4
6
8
1
0
S
o
l
i
d
S
t
a
t
e
S
p
e
e
d
C
o
n
t
r
Lock Unlock
f
o
r
e
i
n
s
e
r
t
i
n
g
o
f
r
e
m
o
v
i
n
g
p
a
r
t
s
e
a
vy D
u
ty