KitchenAid ELECTRA KCDE200 - Page 4

OPERATING INSTRUCTIONS FOR
CONTINUOUS FEED MODELS
KitchenAid Imperial Model
KitchenAid Electra Model
The Imperial and Electra continuous
feed disposers have a one-piece cover
that acts only as a seal. A wall switch is
used to turn the disposer on or off.
4. Allow both the disposer and cold
water
to
run
for
about
30
seconds
after
grinding
action
is
completed.
This
will
assure
that
any
bone
slivers
or
other
hard
objects
that
could
cause
jams
are
flushed
from
the
grind
chamber.
This
will
also
assure
proper
flushing
of
the
external
drain
line.
5. Turn wall switch to OFF position.
To SEAL the cover for holding water in
the sink, press the cover firmly in the
disposer opening. CAUTION: Do not
operate the disposer with the cover in
the SEAL position.
TO OPERATE:
1. Remove cover from sink opening
and turn on a good flow of COLD
water. (Cold water hardens greasy
substances, making it easy to grind
them into tiny particles. Cold water also
keeps grease from sticking to the drain
lines.) It is important and absolutely
necessary that cold water flows into the
disposer while it is in operation. If you
have a double sink, make sure the fau-
cet points to side where the disposer is
installed.
2. Turn wall switch to ON position.
3. Scrape food waste into disposer
opening. The splash guard will reduce
splashing. Mix soft and hard food waste
items for most efficient grinding.