KitchenAid ELECTRA KCDE200 - Page 5

— OPERATING INSTRUCTIONS FOR
gua BATCH FEED MODELS
[i
ME KitchenAid Superba Model
SE itchenAid Deluxe Model
Ea
GQ The Superba and the Deluxe Models TO OPERATE:
are batch feed disposers which operate
when the MAGNESTART” Cover Con-
trol is in position, keeping food waste in
and other objects from accidentally fall-
ing into the disposer during operation.
The patented MAGNESTART Cover
Control has a magnet set into the base.
The position of the magnet is indicated
by an arrow surrounding the word
KitchenAid on the handle. When the
Cover Control is placed in the proper
position in the sink opening, the magnet
actuates a switch and the disposer
starts.
POSITIONS OF THE COVER
CONTROL
Grind Position: Looking into the sink
opening, you will see two sets of “V”
grooves stamped into the upper hous-
ing. These grooves support the cover
for operation. Note the red arrow in one
set of the “V” grooves. Point the MAG-
NESTART Cover Control arrow to the
red arrow in the sink opening and drop
in place. Do not rotate cover control.
In this position—the Grind Position —
nothing but water can enter the grinding
chamber and the disposer will start.
Seal Position: To seal the sink so that
it will retain water, point MAGNESTART
Cover Control between the two sets of
“V” grooves and drop in place.
Drain Position: To drain the sink,
point MAGNESTART Cover Control
arrow to set of “V” grooves opposite
those with the red arrow and drop in
place. When disposer is not in use,
the MAGNESTART Cover Control
should be kept in DRAIN Position
to keep foreign objects from drop-
ping into the unit.
1. Remove MAGNESTART Cover Con-
trol and scrape food waste into disposer
opening. Mix soft and hard food waste
items for most efficient grinding.
2. Turn on a good flow of COLD water.
(Cold water hardens greasy sub-
stances, making it easy to grind them
into tiny particles. Co/d water also
keeps grease from sticking to the drain
lines.) It is important and absolutely
necessary that cold water flows into the
disposer while it is in operation. If you
have a double sink, make sure the fau-
Cet points to side where the disposer is
installed.
3. Place MAGNESTART Cover Control
in GRIND Position to start disposer. Do
not rotate cover control.
4. Allow both the disposer and cold
water to run for about 30 seconds after
grinding action is completed. This will
assure that any bone slivers or other
hard objects that could cause jams are
flushed from the grind chamber. This
will also assure proper flushing of the
external drain line.
5. Lift MAGNESTART Cover Control to
stop disposer— Never rotate cover
control.