KitchenAid KDRP467K User Manual

36" (91.4 cm) Classic Commercial Style
Dual Fuel Convection Range
®
PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS
CABINET OPENING DIMENSIONS
KDRP467K
Gas supply: Use 3/4" (1.9 cm) rigid pipe
gas supply line to the range location. A
smaller size pipe on longer runs may result
in insufficient gas supply. With L.P. gas,
piping or tubing size can be 1/2" (1.3 cm)
minimum. If local codes permit, it is
recommended that new flexible metal
tubing, design-certified by CSA, 4-5 feet
(122-152.4 cm) long, 5/8" (1.6 cm) or 3/4"
(1.9 cm) I.D., be used for connecting the
range to the rigid gas supply line. A 1/2"
(1.3 cm) male pipe thread is needed for
connection to pressure regulator female
pipe threads. An individual manual shutoff
valve must be located in the same room,
but external to the range.
Electrical: A four-wire or three-wire, single
phase, 120/240-volt, 60-Hz, AC-only,
electrical supply is required on a separate
30-amp circuit, fused on both sides of the
line. A time-delay fuse or circuit breaker is
recommended.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 9760618B
09-04-08
O
FF
F
F
O
O
F
F
F
F
O
O
F
F
F
F
O
O
F
F
F
F
O
O
F
F
F
O
O
F
F
F
F
O
F
F
O
F
F
O
F
F
O
FF
O
B
C
D
F*
G
H
A
E
F
B
C*
D
E
F
G
H
I
J
L
M
K
N
O
**
A
Cabinet opening dimensions shown are for 25" (64 cm) countertop
depth, 24" (61 cm) base cabinet depth and 36" (91.4 cm)
countertop height.
IMPORTANT: If installing a range hood above the range, follow the
range hood instructions for dimensional clearances above the
cooktop surface.
A. 18" (45.7 cm) upper cabinet to countertop
B. 28" (71.1 cm)
C. Junction box to be located in this shaded area. See NOTE*.
D. 4" (10.2 cm)
E. 20" (50.8 cm)
F. 12" (30.5 cm)
G. 5-1/2" (14 cm)
H. Gas line opening to be located in this shaded area
I. 3-1/2" (8.9 cm)
J. 8" (20.3 cm)
K. 36-1/4" (92.1 cm)
L. 4" (10.2 cm) min. clearance from both sides of range to side wall or
other combustible material
M. For minimum clearance to top of range, see NOTE**.
N. 36" (91.4 cm) minimum upper cabinet width
O. 13" (33 cm) maximum upper cabinet depth
*NOTE: Receptacle must be rotated 90° for Canadian installation.
**NOTE: 42" (106.7 cm) minimum when bottom of wood or metal
cabinet is covered by not less than 1/4" (0.64 cm) flame retardant
millboard covered with not less than No. 28 MSG sheet steel,
0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or
0.020" (0.5 mm) copper.
48" (121.9 cm) minimum clearance between the top of the
cooking platform and the bottom of an uncovered wood or metal
cabinet.
A. Backguard (required for some
installations)
B. 45" (114.3 cm) overall height
C. 36" (91.4 cm) cooktop height with
feet loosened 3/4 turn
D. Model/serial rating plate (right
vertical surface of oven door frame.)
E. 36" (91.4 cm) width
F. 26-1/2" (67.3 cm) depth with control
panel*
G.1/4" (0.64 cm) spacer
H. 9-1/4" (23.5 cm) backguard height
*When installed in a 24" (61 cm)
base cabinet with 25" (63.5 cm)
countertop; front of oven door
protrudes 1-7/8" (4.8 cm) beyond
24" (61 cm) base cabinet.

KitchenAid KDRP467K Specifications

General

Type	Freestanding
Fuel Type	Gas
Burners	6
Convection Oven	Yes
Self-Cleaning	Yes
Color	Stainless Steel
Product Type	Range

Summary

Product Model Numbers

Gas Supply Requirements

Details on rigid pipe gas supply lines, flexible metal tubing, and shutoff valve requirements.

Electrical Supply Requirements

Specifies a four-wire or three-wire, 120/240-volt, 60-Hz, 30-amp circuit.

Product Dimensions

Backguard

Backguard dimensions and requirement for some installations.

Overall Height

Total overall height measurement of the range.

Cooktop Height

Cooktop height with feet loosened.

Model/Serial Rating Plate Location

Location of the model/serial rating plate on the oven door frame.

Width and Depth

Width and depth measurements of the range including control panel.

Spacer Dimension

Dimension of a specific spacer (G).

Backguard Height

Height of the backguard.

Cabinet Opening Dimensions

Upper Cabinet to Countertop Clearance

Clearance between upper cabinet and countertop.

Range Depth and Clearances

Clearances for range depth, junction box, and gas line opening.

Side Wall Clearance

Minimum clearance from range sides to wall or combustible material.

Minimum Clearance to Top of Range

Minimum clearance to top of range, refer to NOTE**.

Upper Cabinet Width and Depth

Minimum upper cabinet width and maximum upper cabinet depth.

Canadian Installation Note

Receptacle must be rotated 90° for Canadian installation.

Cabinet Bottom Protection Note

Minimum clearance when cabinet bottom is covered with flame retardant material.