codesandordinances.
Check locationwhere hot water
dispenserwill be installed.Proper
installationis your responsibility.
Make sure you have everything
necessaryfor correctinstallation.It is
the responsibilityof the installerto
complywith installationspecifications
and withstate and local plumbing
codes.
Spout requiresa 1-1/16" (2.7 cm) to
1-3/8" (3.5 cm) diameteropeningin
sinkor countertop.Spout can be
installedin placeof sink sprayhose.
For otherinstallations,contacta
qualifiedinstallerfor best procedure
to drilla holethroughyourtype of
sinkor countertop.Thicknessof sink
or countertophole mustnot exceed
1-1/8" (2.9 cm).
Cold water supply connection must
be available.(See "Water supply
requirements,"Page 5.)
Grounded electrical outlet is
required.(See "Electrical
requirements,"Page 5.) The outlet
shouldbe located within42"
(106.7 cm) of hot water dispenser
tank.
Ifspout is not to be Installed In sink
spray hose opening,contact a
qualified installerfor the best
procedure for cutting a spout
opening in your type of sink or
countertop.
Plumbing connections mustcomply
with all sanitary,safetyand plumbing
codes.
Do Not store or operatehot water
dispenserbelow 32°F (O°C).
Do Not usa pipesealing compounds.
They may get inside dispenser and
cause an unpleasanttaste or smell.
Water connections use quick-
connect fittingswhich Do Not
require seanngcompounds to keep
them from leaking.
This hot water dispenser isNot a
water purifier.Some Installations
may requirea waterfiltering system
to Improvethe qualityof water.
Spout Installed In spray hose
opening In sink.
If spout Is not to be
Installed In sink spray hose
openlnn_,cut 14/16"
(2.7 cmj mln. -- 1-3/8
(3.5 cm) max. dis. sink or
countertap cutout
1-1R" (2.9 cm) max.
countertop or sink thickness
valve
To Next Page
Loading...
