KitchenAid KP50PS User Manual

7
Assembling Your Bowl-Lift Mixer
** See page 5.
To Attach Bowl
1. Be sure speed control is OFF and
mixer is unplugged.
2. Place bowl lift handle in down
position.
3. Fit bowl supports over locating
pins.
4. Press down on back of bowl until
bowl pin snaps into spring latch.
5. Raise bowl before mixing.
6. Plug mixer in proper electrical
outlet.**
To Remove Bowl
1. Be sure speed control is OFF and
mixer is unplugged.
2. Place bowl lift handle in down
position
3. Remove flat beater, wire whip, or
dough hook.
4. Grasp bowl handle and lift straight
up and off locating pins.
To Raise Bowl
1. Rotate handle to straight-up
position.
2. Bowl must always be in raised,
locked position when mixing.
To Lower Bowl
1. Rotate handle back and down.
Injury Hazard
Unplug mixer before inserting
or removing beaters.
Unplug mixer before cleaning.
Failure to do so can result in
broken bones or cuts.
WARNING

!
To Attach Flat Beater, Wire Whip,
or Dough Hook
1. Turn speed control to OFF and
unplug.
2. Slip flat beater on beater shaft and
press upward as far as possible.
3. Turn beater to
right, hooking
beater over the
pin on shaft.
4. Plug mixer in
proper electrical outlet.**
To Remove Flat Beater, Wire
Whip, Or Dough Hook
1. Turn speed control to OFF and
unplug.
2. Press beater upward as far as
possible and turn left.
3. Pull beater from beater shaft.
4. Plug mixer in proper electrical
outlet.**
Household mixer SPEED Control
Plug mixer in proper electrical
outlet.** Speed control lever should
always to be set on lowest speed for
starting, then gradually moved to
desired higher speed to avoid
splashing ingredients out of bowl.
See page 12 for Speed Control Guide.
RAISE
PIN
Solid State Speed Control
Off Stir 2 4 6 8 10

KitchenAid KP50PS Specifications

General

Brand	KitchenAid
Model	KP50PS
Category	Mixer
Language	English