Stand Mixer Service Manual LIT4177310-C 2005 KitchenAid
Appendix B-1
FASTENER REQUIREMENTS
A. FASTENER AND TORQUE VALUES
LISTED BELOW ARE THE FASTENERS AND TORQUE VALUES USED IN THE ASSEMBLY OF THE KITCHENAID.
DESCRIPTION TORQUE IN LBS.
BASE & COLUMN MOUNTING SCREWS (4)(K45) 125/150
BEARING BRACKET ASSEMBLY RETAINING NUTS (2) 15/20
BOWL SCREW CAP RETAINING SCREWS (3)(K45) 24/32
BOWL SPRING MOUNTING SCREWS (2)(K5) 18/23
BOWL SUPPORT MOUNTING SCREWS (2)(K5) 18/23
BRUSH HOLDER CAPS (2) 4/6
BRUSH HOLDER SET SCREWS (2) 3/5
*CONTROL LEVER (SPEED) PIVOT SCREW (1) 18/23
CONTROL PLATE LOCKING NUTS (2) MIN 9
ELECTRIC CORD GROUNDING SCREW (1) 18/23
END COVER RETAINING SCREW (1) 4/7
FEET MOUNTING SCREWS (4)(K5) 4/6
**GEAR CASE RETAINING SCREWS (9) 18/20
LOCK WASHER UNDER 1 GEAR CASE MOUNTING SCREW (K45)(REAR)
LOCK WASHER UNDER 1 BASE MOUNTING SCRW (KSMC50 ONLY)
LOWER GEAR CASE AND COLUMN MOUNTING SCREW (4)(K5) 125/150
AGITATOR SHAFT BEATER DRIVE PIN (1)(KSMC50) 30/40
*GUARD PIN (1)(KSMC50) HAND TIGHT
CIRCUIT BREAKER NUT (1) HAND TIGHT
HEAD LOCK PIVOT SCREW (1)(K45) 18/23
HINGE PIN LOCKING SCREW (1)(K45) 24/33
***STATOR RETAINING NUTS (2) MIN 30
PHASE CONTROL RETAINING SCREW (1) 4/5
PLANETARY GEAR RETAINING SCREW (1)(KSMC50) 18/23
TRIM BANDMOUNTING SCREW (2) 8/10
EUROPEAN GROUND AND FILTER MOUNTING SCREWS MIN 18
STATOR STUD 3/5
*** IF TORQUE GUNS RE SET AT 15/20 LBS.,NUTS MUST BE HAND TORQUED AT LEAST 1/4 OF A TURN WITH A HAND NUT
RUNNER
WORM GEAR BRACKET MOUNTING SCREWS (3) 18/23
BOWL ADJUSTMENT SCREW (K5) 10/12
* BEFORE ASSEMBLY, DIP SPEED CONTROL LEVER PIVOT SCREW AND GURAD PIN INTO A LOCKTITE #271 SOLUTION
To Next Page
Loading...
