KitchenAid KSBS25FKBL00

Questions and Answers

T
Travis DelacruzAug 8, 2025
What to do if the KitchenAid KSBS25FKBL00 compartment is too warm?
- D
  Dustin BergAug 8, 2025
  If your KitchenAid Refrigerator compartment is too warm, there are several potential causes. First, ensure that the refrigerator control is not set too warm; try setting it to a lower temperature. Check the refrigerator thermistor's wires and connectors, and run diagnostics, confirming any defects with an ohms test. Look for any ice or blockage in the air door and run a diagnostics test to operate it. Also, check if the evaporator fan motor is running by running a diagnostics test and inspecting the fan blade for blockages. Voltage between pins P7-9 and P7-10 should be 5-17vdc; if correct, replace the motor. Ensure there is no blocked airflow at the air door outlet and returns. Finally, consider whether the freezer compartment is also warm.
S
Stephanie JohnsonAug 13, 2025
Why is my KitchenAid Refrigerator freezer compartment too warm?
- E
  Edward RiveraAug 13, 2025
  If your KitchenAid Refrigerator's freezer compartment is too warm, there could be several reasons. Start by ensuring the freezer control isn't set too warm; adjust it to a lower temperature. Inspect the freezer thermistor's wires and connectors, running diagnostics and confirming any defects with an ohms test. Check if the evaporator fan motor is running properly, look for any blockages on the fan blade, and verify the voltage between pins P7-9 and P7-10 is within 5-17vdc; replace the motor if the voltage is correct. Examine the condenser fan motor for obstructions and test it. Finally, check for frost blocking the evaporator and test the defrost system, heater, and bi-metal.
F
fwatsonAug 19, 2025
What to do if KitchenAid Refrigerator compartment is too cold?
- S
  Sarah PageAug 19, 2025
  If the refrigerator compartment in your KitchenAid Refrigerator is too cold, the following could be the reasons. First, make sure that the refrigerator control isn't set too cold; if it is, set it to a higher temperature. Check the wires and connectors of the refrigerator thermistor and run a diagnostics. If the diagnostics indicates a defective thermistor, confirm it with an ohms test. Check the air door for being stuck open or inoperative, look for ice or other blockage. Run diagnostics test to operate air door and check for proper DC input voltage. If voltage is normal and door will still not operate, replace air door. Inspect the air door seal for damage, and repair or replace it if necessary. Finally, run diagnostics test to operate air door to check main PC board.
J
johnstondanaAug 26, 2025
Why does my KitchenAid Refrigerator run too long?
- L
  Luis DiazAug 26, 2025
  Your KitchenAid Refrigerator is designed to run almost constantly at the lowest possible compressor speed. Starting and stopping the compressor uses more power than continuous low rpm operation.
B
Benjamin GordonSep 1, 2025
What to do if the condenser fan runs but the compressor will not start in my KitchenAid KSBS25FKBL00?
- W
  wbirdSep 1, 2025
  If the condenser fan runs but the compressor won't start in your KitchenAid Refrigerator, it could be due to several reasons. There might be no DC control voltage from the main PCB to the inverter board. Control voltage wires might be loose or reversed; check connections and repair as needed. The compressor or the inverter board might be faulty.

Summary

KitchenAid 2001 K Model Refrigerator Technical Education

Technical Education Overview

Introduction to the technical education material for the KitchenAid 2001 K Model refrigerator.

General Information and Safety

Safety First

Emphasizes the importance of safety precautions and the meaning of safety alert symbols.

Electrical Power Supply and Grounding

Details electrical safety, grounding, and connection requirements for the appliance.

Electrostatic Discharge (ESD) Sensitive Electronics

Provides guidelines for handling sensitive electronic components to prevent ESD damage.

Model and Serial Number Information

Model and Serial Number Label Locations

Shows the physical locations of the model/serial number label and tech sheet on the refrigerator.

Product Specifications

Refrigerator Warranty Details

Installation Procedures

Leveling the Refrigerator

Instructions on how to properly level the refrigerator using adjustable rollers and bolts.

Theory of Operation

Electronic Control Panel Overview

Explains the function and features of the electronic control panel and its indicators.

Temperature Control Logic

Details how the electronic control manages freezer and refrigerator temperatures via sensors and fan speed.

Compressor, Inverter, and Fan Motor Operations

Describes the function and operation of the compressor, inverter, and evaporator fan motor.

Defrost Cycles and Power Interruption

Explains the adaptive defrost cycle, power interruption recovery, and failure default modes.

Air Circulation System

Illustrates and describes the airflow path between refrigerator and freezer compartments.

Component Access and Removal

Component Locations Overview

Diagrams showing the location of major components within the refrigerator/freezer.

Removing Touch;Display Board and Motorized Air Door

Step-by-step guide for accessing and removing the touch control assembly and motorized air door.

Removing a Thermistor

Detailed procedure for safely removing and replacing refrigerator and freezer thermistors.

Removing a Door Switch

Instructions for accessing and disconnecting the refrigerator and freezer door switches.

Removing a Light Socket

Procedure for safely removing and replacing the light socket assembly in the refrigerator compartments.

Removing the Water Reservoir

Step-by-step guide for removing the water reservoir and associated tubing.

Removing Ice Maker and Auger Motor

Procedure for removing the ice maker assembly and the auger motor/crush/cube solenoid.

Removing Evaporator Fan Motor, Bimetal, and Defrost Heater

Detailed steps for removing the evaporator fan motor, bimetal, and defrost heater assembly.

Removing the Condenser Fan Motor

Instructions for safely removing and replacing the condenser fan motor.

Removing the Compressor

Procedure for safely disconnecting and removing the main compressor unit.

Removing the Inverter Assembly

Steps to safely remove the inverter assembly connected to the compressor.

Removing the Main Control Board Assembly

Detailed procedure for safely removing the main electronic control board assembly.

Removing the Water Dispenser Fill Tube

Guide to removing the water dispenser fill tube and associated panel.

Removing the Water Valve

Instructions for safely disconnecting and removing the water inlet/outlet valve.

Removing Freezer Door Handles and Door

Procedure for removing freezer door handles and the entire freezer door.

Removing a Roller Assembly

Steps for removing and replacing the roller assembly at the base of the refrigerator.

Component Testing Procedures

Thermistor Testing

Details on testing thermistor resistance and voltage output for accurate diagnosis.

Fan Motor Testing

Procedures for testing the resistance and operation of evaporator and condenser fan motors.

Compressor & Inverter Testing

Steps for testing compressor windings resistance and inverter board voltage outputs.

Motorized Air Door & Defrost System Testing

Procedures for testing the motorized air door motor and the defrost heater/bimetal continuity.

Main Control Board Testing

Specifications and procedures for testing voltages and signals on the main control board.

Solenoid and Auger Motor Testing

Testing procedures for the crush/cube solenoid and the ice maker auger motor resistance.

Water Valve Solenoid and Door Switch Testing

Testing procedures for water valve solenoids and door switch continuity/open circuit.

Diagnosis and Troubleshooting Guide

Pre-Diagnostics Checks and Mode Entry

Essential checks before diagnostic mode and instructions on how to enter it.

Diagnostic Chart and Troubleshooting Steps

A chart detailing diagnostic test steps, expected results, and component status.

Troubleshooting Common Problems

A guide correlating common problems with possible causes and recommended test procedures.

Water Filter Input (WFI) Test

Procedures to test the water filter indicator system and confirm water valve monitoring.

Wiring Diagrams and Strip Circuits

Wiring Diagram Overview

A comprehensive wiring diagram illustrating the electrical connections of all major refrigerator components.

Cooling Circuits Strip Diagrams

Strip circuit diagrams detailing the electrical paths for the compressor and condenser fan motor.

Evaporator Fan Motor and Defrost Cycle Strip Diagrams

Strip circuit diagrams showing the electrical paths for the evaporator fan motor and defrost heater.

Product and Warranty Information Sources