ENGLISH
USING THE FRUIT/VEGETABLE STRAINER ATTACHMENT | 5
USING THE FRUIT/VEGETABLE STRAINER
ATTACHMENT
4
Insert the Collar over the Strainer Cone and rotate
clockwise to secure.
Slide the Strainer Shield over the cone and latch on
the top of ring.
5
Place the Splash Lid on the Strainer Shield.
Collar
Notch
Tab
ASSEMBLING THE FRUIT/VEGETABLE STRAINER ATTACHMENT TO
THE STAND MIXER
1
Turn the Stand Mixer off and unplug.
2
For Stand Mixers with a hinged attachment hub
cover: Flip up to open.
For Stand Mixers with a removable attachment hub
cover: Turn the attachment knob counterclockwise to
remove attachment hub cover.
3
Insert the attachment shaft housing into the
attachment hub, making certain the power shaft fits
into the square hub socket. If necessary, rotate the
attachment back and forth. The pin on the attachment
housing will fit into the notch of the hub rim when in
the proper position.
4
Tighten the Stand Mixer attachment hub knob
clockwise until the attachment is completely
secured to the Stand Mixer.
To Next Page
Loading...
