EasyManuals Logo

KitchenAid KUDP02CR User Manual

KitchenAid KUDP02CR
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8
Do not load glasses, cups, or plastic items in the bottom rack.
Load small items in the bottom rack only if they are secured in
place.
Load plates, soup bowls, etc., between tines.
Overlap the edges of plates for large loads.
Load soup, cereal, and serving bowls in the rack in a variety of
ways depending upon their size and shape. Load bowls
securely between the rows of tines. Do not nest bowls
because the spray will not reach all surfaces.
Load cookie sheets, cake pans, and other large items at the
sides and back. Loading such items in front can keep the
water spray from reaching the detergent dispenser.
Secure heavily soiled cookware face down in the rack.
Make sure pot handles and other items do not stop rotation of
the spray arm(s). The spray arm(s) must move freely.
Do not load items between the bottom rack and the side of
the dishwasher tub because they might block the water inlet
opening.
FLEXI-FOLD DOWN™ flexible tines
You can fold down one or both rows of tines at the back of the
bottom rack.
1. Grasp the tip of the tine that is in the tine holder.
2. Gently pull the tine out of the tine holder.
3. Lay the row of tines down in the rack to make room for larger
dishes, bowls, pots, pans or roasters.
Knife holder
Use the knife holder on the left side of the bottom rack to hold
knives that are too large for the silverware basket. Place knives in
the holder as shown.
IMPORTANT: Remove knives before removing the knife holder
from the rack.
To remove the knife holder
1. Slide up to release the hooks over the rack wire.
2. Lift knife holder out of rack.
To install the knife holder
1. Align the knife holder with the bottom rack as shown in the
illustration below.
2. Place the bottom slotted guide over the vertical wire in the
side of the rack.
3. Place the hooks, located on the back of the knife holder, over
the center rack wire and gently push down to lock into place.
12 place setting
Utensil load
Mixed load
A. Top alignment
B. Bottom slotted guide
C. Knife holder hooks
A
B
C

Other manuals for KitchenAid KUDP02CR

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KitchenAid KUDP02CR and is the answer not in the manual?

KitchenAid KUDP02CR Specifications

General IconGeneral
BrandKitchenAid
ModelKUDP02CR
CategoryDishwasher
LanguageEnglish

Related product manuals