TheCycleMonitorallowsyouto seewhat
portionof acycleyourdishwasheris in.The
Cleanlightglowswhena cyclehasfinished,
Allotherlightswillturnoff.TheCleanlight
willturnoffwhenyouopenthedoor,
CYCLE MONITOR
WASH RINSE DRY CLEAN
[ II II II II II II II ]
The Water Heating light glows while water in
[ the dishwasher is
WATER HEATING heating, Wash or rinse
action continues while
the water heats,
_::: _ ,(: ::::i,
Fill the rinse agent dispenser when Rinse
Aid Empty is lit to
RINSE AID EMPTY improve drying and
prevent spots or
streaks,
Use Child Lock to prevent your dishwasher
[ from being turned on
CHILD LOCK accidentally, No wash
selections or options
can be selected when
Child Lock is on, and the dishwasher will
not start,
NOTE: You will still be able to open the
dishwasher door.
% .;
Press Energy Saver Dry for 5 seconds, The
Child Lock light will glow for 30
seconds, All other lights will be off.
The Child Lock light will turn back
on for 30 seconds if any pad
is pressed during this time.
Press Energy Saver Dry again for 5 seconds,
The Child Lock light will turn off.
/
Press new Wash Selection and Option pads,
{;ii:_:
1. Press the Cancel pad to drain any water
and to reset the control,
2. Open the door and check the detergent
dispenser to be sure it is properly filled for
the new cycle,
3. Close the door,
4. Press new Wash Selection and Option
pads, then press the Start pad.
NOTE: If the dishwasher will not start, make
sure Delay Hours has not been selected,
To Next Page
Loading...
