Need help?Do you have a question about the KitchenAid KUIA18NNJ and is the answer not in the manual?
Importance of safety messages, symbols, and precautions.
Requirements for safe electrical connection and proper grounding.
Handling precautions for ESD sensitive electronic components to prevent damage.
Location of the model and serial number label on the appliance.
Designation breakdown for models manufactured before 2003.
Designation breakdown for models manufactured from 2003 onwards.
Specifies the required electrical supply and grounding for safe operation.
Step-by-step instructions for connecting the water supply line to the ice maker.
Guidelines for installing the gravity drain system for the ice maker.
Instructions for connecting the drain pump system if applicable.
Overview of the refrigeration, water, and electrical systems.
Details the water supply, recirculation, and flushing mechanisms.
Explains the electrical power, control, and cycling of the ice maker.
Describes the process of making ice, including conditions and off cycles.
Explains the cycle where ice is released and collected.
Details the diagnostic and cleaning modes for the ice maker.
Illustrates the location of various components within the ice maker.
Step-by-step guide to removing key components.
Instructions for accessing and removing components from the control housing.
Detailed steps for removing the water recirculation pump.
Procedure for safely removing the condenser fan motor.
Step-by-step instructions for removing the evaporator unit.
Instructions for disconnecting and removing the water inlet valve.
Guide for removing the hot gas valve and its solenoid.
Steps to safely remove the condenser unit.
Procedure for removing the compressor and its associated parts.
Instructions for removing the internal drain pump from specific models.
Steps for removing the door and gasket on 15-inch models.
Instructions for removing the door and gasket on 18-inch models.
Procedure and resistance values for testing the bin thermistor.
Procedure and resistance values for testing the evaporator thermistor.
Steps and resistance values for testing the cutter grid.
Procedure and resistance values for testing the cutter grid transformer.
Procedure and resistance values for testing the water recirculation pump.
Procedure and resistance values for testing the condenser fan motor.
Procedure and resistance values for testing the water inlet valve solenoid.
Procedure and resistance values for testing the hot gas valve solenoid.
Procedure for testing compressor windings and related components.
Procedure and readings for testing the pushbutton switch assembly.
Explains how water quality impacts ice production and appearance.
A table listing common problems, causes, and test actions.
A visual guide to diagnosing issues using the control board.
Schematic showing electrical connections and components.
Simplified circuit diagrams for ice making and harvest modes.
Simplified circuit diagrams for diagnostic/clean modes.
Recommendations and procedures for cleaning the ice maker.
How to adjust ice thickness using control board jumpers.
General| Power | 115V |
|---|---|
| Finish | Stainless Steel |
| Control Type | Electronic |
| Refrigerant Type | R134a |
| ENERGY STAR Qualified | No |
| Frequency | 60 Hz |
| Color | Stainless Steel |
| Width | 18 inches |
| Storage Capacity | 25 lb |
| Ice Cube Type | Clear |
To Next Page
