Media, iframe, embed and object tags are not supported inside of a PDF.
Media, iframe, embed and object tags are not supported inside of a PDF.
Attaching the Glass Bowl to the Stand Mixer
1. Be sure the speed control is OFF, and Stand Mixer is unplugged.
2. Place the bowl-lift lever in the down position.
3. Fit bowl supports over locating pins.
4. Press down on the back of the Glass Bowl until the bowl pin snaps into the spring latch.
5. Raise the Glass Bowl before mixing.
To Raise the Glass Bowl
1. Rotate the lever to the straight-up position.
2. Bowl must always be in a raised, locked position when mixing.
To Lower Glass Bowl
1. Rotate the lever back and down.
To Remove the Glass Bowl from Stand Mixer
1. Be sure the speed control is OFF, and Stand Mixer is unplugged.
2. Place the bowl-lift lever in the down position.
3. Remove the flat beater, wire whip, or dough hook.
4. Grasp the bowl handle and lift straight up and off locating pins.
Tips for use
• This is not recommended for microwave oven use.
• To avoid product damage, do not use the Glass Bowl in areas of high heat, such as an oven or on a stovetop.
• The Glass Bowl can only be used with F-series attachments (see "Accessories"). The "F" is embossed on each
beater.
Care and cleaning
The Glass Bowl may be washed in an automatic dishwasher, or cleaned thoroughly in hot sudsy water and rinsed
https://producthelp.kitchenaid.com/Countertop_Appliances/Stand_Mixers/Product_Info/Stand_Mixer_Tips_and_Tricks/Glass_…
Updated: Sun, 11 Jun 2023 22:54:27 GMT
Powered by
2
To Next Page
Loading...
