TERMS AND CONDITIONS:
Refrigeration
1 YEAR WARRANTY
All claims for parts or labor must be made directly through Kitma.AII claims must include: model number of the
unit, the serial number, proof of purchase, date of installation, and all pertinent information supporting the
alleged defect.In case of compressor replacement under warranty, either compressor or compressor tag must
be returned to Kitma along with above listed information.Failure to comply with warranty policies will
result in voiding claims.
One Year Parts & Labor Warranty
Kitma warrants all new refrigerated components, such as the cabinet and all parts, to be free from defects in
materials or workmanship. Kitma's obligation under this warranty is limited to a period of one(1) years from
the date of original installation or 12 months after shipment date from Kitma, whichever occurs first.All parts
covered under this warranty that are defective within one(1) years of original installation or
twelve
(12) months
after shipment date from manufacturer, whichever occurs first, are limited to repair or replacement (including
labor charges, of defective parts or assemblies). The labor warranty shall include standard straight time labor
charges only and reasonable travel time, as determined by Kitma.
Additional One Year Compressor Warranty
In addition to the one (1) year warranty stated above, Kitma warrants its sealed compressor to be free from
defects in both material and workmanship under normal and proper use and maintenance service for a period
of one(1) additional years from the date of original installation, but not to exceed one(1) years. Compressors
that have been determined to be defective from Kitma within this extended period will be either repaired or
replaced with a compressor or compressor parts of similar design and capacity according to Kitma's
discretion.The one(1) year extended compressor warranty applies only to sealed parts of the compressor and
does not apply to any other parts or components. This includes, the cabinet, paint finish, temperature
control, refrigerant, metering device, motor starting equipment, fan assembly, and other electrical components,
etc.
404A / 134a Compressor Warranty
The one-year compressor warranty detailed above will be void if the following procedure is not carefully
adhered to:
1.
This system contains R404A or R290 refrigerant and lubricant. The lubricant has rapid moisture absorbing
qualities.
2.
Drier replacement is very important and must be changed when a system is opened for servicing.
3.
Micron level vacuums must be achieved to insure low moisture levels in the system.
4.
Compressor must be obtained through Kitma, unless otherwise specified in writing, through Kitma's
warranty department.
To Next Page
Loading...
