Kitsound JIVE - Advanced Features and Maintenance; Setting Alarm 1; Setting Alarm 2; Sleep Timer Setting

10 11
Setting Alarm 1
1. In DAB or FM mode, press the ALARM button
2. Press the SELECT button to confirm. The hour digit will then flash on the display. Rotate the SELECT dial to choose the alarm hour time
and press the SELECT button to confirm
3. The minute digits will then be flashing. Repeat the steps above to confirm the alarm minute. Note: If in 12 hour mode, press the SELECT
dial to confirm AM or PM
4. ‘Duration’ will be showing on the display. Press the SELECT dial to choose 15, 30, 45, 60 or 90 minutes
5. ‘Source’ will then show on the display. Rotate the SELECT dial to confirm the wake up source as ‘Buzzer, FM or DAB’
6. ‘Daily’ will show on the display. Rotate the SELECT dial to choose ‘daily’, ‘weekdays’, ‘weekends’ or ‘once’ to confirm the alarm occurrence
7. To set the alarm volume, rotate the SELECT dial and press to confirm
8. ‘Alarm on’ will flash on the display. Rotate the SELECT dial to change between ‘on’ and ‘off’ and press to confirm. ‘Alarm saved’ will be
shown on the display
Note: The clock icon will always flash on the display during the alarm setting process.
Note: In alarm mode, if you don’t begin setting the alarm within 3 seconds, the Jive will exit alarm mode.
Setting Alarm 2
When Alarm 1 is displayed, rotate the SELECT dial to show Alarm 2, then follow the instructions above from step 2.
Sleep setting
When the Jive is in DAB or FM mode, press the SLEEP/SNOOZE button so that ‘set sleep time’ shows on the display. Rotate the dial to select
the sleep time from 15, 30, 45, 60 or 90 minutes and press to confirm the setting.
Specifications
• Frequency response: 100 Hz – 12 kHz
• Drivers: 3 inch x 2
• Output power: 2 x 2 W
• Unit size: H155 x W110 x D270 (mm)
• Weight: 1.25 kg
Recycling
Your product and batteries must be recycled or disposed of properly. Please contact your local recycling centre for more information on
proper disposal.
Care and maintenance
Wipe the unit with a soft dry dust cloth. Do not use any wax, polish sprays or abrasive cleaners on it.
Caution: Never allow any water or other liquids to get inside the unit while cleaning.
Troubleshooting
We hope you’ve now got all the information you need to get started, but if you’re having problems with anything, please feel free to contact
us at: support
@
kitsound.co.uk
We apologise for any inconvenience caused by minor inconsistencies in these instructions, which may occur as a result of product improvement and development.