Kiwi KHT-8490 - Before First Use; Wall Mounting Instructions; Initial Operation and Ventilation; Using the Heater

3
KHT-8490 Instruction Manual
EN
USE
BEFORE THE FIRST USE
This device is not suitable for use inside a cabinet
or outside. How to mount the device on the wall
with the mounting diagram on the side.
Using a drill, drill two holes in the wall, at least
200 cm from the ground and 42.5 cm apart. After
drilling the holes, insert the pad and screw it on.
Make sure the screws are securely tightened and
then hang the device on the wall.
There will be a slight odor when the device is
rst turned on. This is normal, ensure adequate
ventilation. This smell is temporary and will
disappear in a short time.
Control panel: Press the ON/OFF button to turn the heater on/o, the heater turns on and
blows Med-heat air and displays the ambient temperature. It delays for 30 seconds before
shutting down by blowing cold wind and the number on the digital display drops to 0 before
shutting down and shutting down.
Press the high heat button to switch from medium heating to high heat, press - or + to adjust
the setting temperature during the heating process, the setting range is from 18-45°C, the
default setting temperature is 26°C. Press the timer button to set the range of 0-8 hours, the
heater will turn o according to the set time.
Remote control: Press the ON/OFF button to turn the heater on while the fan is running
and the panel lights are on. Press the medium-heating power button to operate at 1000W,
press the high-heating power button to operate at 2000W. Press + or - button to adjust its
temperature, the setting range is 18-45°C, default setting temperature is 26°C. Press the
timer button to set the shut-o time from 0-8 hours. Press the button to turn all indicator
icons on the screen on and o. To turn it o, press the power button and it will turn o after
30 seconds.
CLEANING AND MAINTENANCE
Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and bu with a dry cloth. Do not
use any detergents or abrasives and do not allow any water to enter the heater.
This product contains recyclable materials that comply with WEEE guidelines. Do not
dispose of this product as unsorted waste. Please contact your local municipality for
a recycling collection point.