Need help?Do you have a question about the Klark Teknik MIDAS XL250 and is the answer not in the manual?
General| Type | Analog |
|---|---|
| Insert Points | Yes, per channel |
| Phantom Power | Yes |
| Frequency Response | 20Hz - 20kHz |
| Connectors | XLR |
Adjusts input amplifier gain from +15dB to 60dB.
Adjusts boost/cut for Hi Mid EQ (+15dB to -15dB) with a 0dB centre detent.
Sets the frequency range for Hi Mid EQ from 400Hz to 8K.
Adjusts the bandwidth of the Hi Mid EQ from 0.1 to 2 octaves.
Adjusts boost/cut for Bass EQ (+15dB to -15dB) with a 0dB centre detent.
Sets the frequency for the Bass shelving EQ from 20Hz to 200Hz.
Engages or disengages the equaliser in the input channel signal path.
Inverts the phase of the input signal by 180 degrees.
Adjusts boost/cut for Treble EQ (+15dB to -15dB) with a 0dB centre detent.
Sets the frequency for the Treble shelving EQ from 2K to 20K.
Adjusts the bandwidth of the Lo Mid EQ from 0.1 to 2 octaves.
Adjusts boost/cut for Lo Mid EQ (+15dB to -15dB) with a 0dB centre detent.
Sets the frequency range for Lo Mid EQ from 100Hz to 2K.
Adjusts direct output level (+10dB to off) from post-EQ pre-fader signal.
Reconfigures direct output to derive signal pre-insert and EQ.
Controls channel placement in master stereo mix with constant power law.
Adjusts input amplifier gains (+15dB to +60dB) for left and right channels.
Provides +48V phantom power to input connectors for microphones/DI boxes.
Routes left channel signal to both left and right channels.
Adjusts boost/cut for Treble EQ (+15dB to -15dB) at a fixed 10KHz.
Adjusts boost/cut for Mid EQ (+15dB to -15dB) with a 0dB centre detent.
Sets frequency range for Mid EQ from 100Hz to 2K, expandable to 10K with X5.
Expands Mid EQ frequency range to operate between 500Hz and 10K.
Selects bandwidth for Mid EQ: 1.5 octave or 0.3 octave.
Adjusts boost/cut for Bass EQ (+15dB to -15dB) at a fixed 100Hz.
Engages or disengages equalisers in the input channel signal paths.
Continuously adjustable Hi Pass filter from 20Hz to 400Hz.
Inverts the phase of the input signal by 180 degrees.
Attenuates input signal by 25dB for high output sources.
Routes right channel signal to both left and right channels; mono sum if both active.
Engages Hi Pass filter before insert points.
Connects post-fader channel signals to master stereo bus via balance control.
Mutes input channel at all points except insert send.
To Next Page