EasyManua.ls Logo

Klarstein 10010174 - Page 16

Klarstein 10010174
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Allow the beer to run down the inside of the glass and slowly straighten the glass while dispensing until
it is upright towards the end. Place the glass on the drip plate and wait about 1 minute until the foam
has settled. Ensure that the glass is not located directly under the beer tap so that no drops fall into the
bear foam.
Repeatthedispensingprocessuntilthebeerandfoamareinthecorrectproportion.Thisisthecase
whentheheadisabouttwonger’sbreadthhighandslightlyovertherimoftheglass.
Cleaning
To clean the beer dispenser and/or to replace the keg, the procedure for this is as follows:
1. Press the lid opener.
2. Take out the tap and the keg
Note: The silicon sealing ring is a wearing part. If excessive carbon losses are noticed during use, replace
the silicon sealing ring with the supplied spare seal
3. Removetheclampsfromtherimofthekegandpullthedispensingunitoutofthekegquicklyand
evenly.Asthebeertapmaynotbemoistduringextraction,removalmaytakesomeeort.
rlegen
Attention: Never remove the dispensing unit from the keg when pressurized. To change the keg before it is
empty, remove the keg together with the dispensing unit from the dispenser. Position it in such a way that the
beerisabletoowoutintoasuitablecontainerandpullthetaphandleuntilnomorebeerisdispensed.
Cleaning
In order to keep the quality of the dispensed beer at a consistently high level, it is important to clean the dis-
penser thoroughly.
Thecleaningintervalsarespeciedinthefollowing
Attention: Never use scouring pads, aggressive scouring agents, acetone, benzene, acids, thinner, vinegar or
similar for cleaning purposes.
Cleaning after each use:
Both the collecting tray and drip tray should be cleaned after each use of
the dispenser to ensure perfect hygiene. For this purpose, remove both the
collecting tray and drip tray from the dispenser and pour the collected beer
into the drain, subsequently clean both parts with hot water (using a small
amount of washing/up liquid if necessary). Attention, to avoid scald when
washing, water cannot be very hot. Drip tray can wash with washer, but
painted collecting tray is not dishwasher proof.
It is recommended to also clean the tube at the front of the beer tap after
each use.
As illustrated in the below photo, please connect cleaning tube with con-
nectingtubeandwaterfaucet,opentheDispensingtaphandlerst,then
open the water faucet, let the water go through the connecting tube and
outowoftheSpout.
rlegen
rlegen
rlegen
16

Related product manuals