EasyManua.ls Logo

Klarstein 10028010 - Cleaning and Care; Troubleshooting

Klarstein 10028010
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
EN
CLEANING AND CARE
Do not use chemical cleaners, abrasives or solvents for cleaning.
Switch off the refrigerator by turning down the temperature control knob and pulling
the plug out of the stretch socket.
Wipe the inside and outside of the refrigerator with a damp cloth and a little
detergent, wipe with clear water and then dry.
Clean the storage compartments, accessories and gasket in warm soapy water,
rinse them clean and then dry them thoroughly.
Clean the door seals with warm soapy water.
Replace all parts, plug in the plug and turn the thermostat to the desired
temperature.
TROUBLESHOOTING
Problem Possible cause Solution
Appliance does not work. Mains plug is not plugged in
or is loose
Insert mains plug.
Fuse has blown or is defective Check fuse, replace if
necessary.
The food is too warm. Temperature is not properly
adjusted.
Please look in the initial
Temperature Setting section.
Door was open for an
extended period.
Open the door only as long as
necessary.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
Turn the temperature regulation
to a colder setting temporarily.
The appliance is near a heat
source.
Please look in the installation
location section.
Appliance cools too much. Temperature is set too cold. Turn the temperature regulation
knob to a warmer setting
temporarily.
Unusual noises. Appliance is not level. Re-adjust the feet.
The appliance is touching the
wall or other objects.
Move the appliance slightly.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
If necessary, carefully bend
the component out of the way.

Related product manuals